Hart Products – RW Hart and Son

Hart Varmint Pedestal (Without Top)

Master Admin — Sat, 12 Jun 2021 16:39:57 +0000

(No Top) Comes with bearing, threaded legs, 3/4″ stem, two (2) T-Handles and Mariner wheel – Black.

Hart Shim Pack – .505 – .600 & .860 Hole Spacing

Master Admin — Sat, 12 Jun 2021 16:39:42 +0000

Hart shims are used to shim the low ring, until alignment is close, then you can lap the rings, with a lapping bar, to achieve perfect alignment, and prevent damaged scope tubes.

Shim packs available in .505-.600 & .860 hole spacing.

They can also be used to increase or decrease MOA in scope.

Each kit contains 7 skims: 2 – .002, 1 – .005 & 4 – .010

Hart Spring Loaded Bolt Stop

Master Admin — Sat, 12 Jun 2021 16:39:42 +0000

The Hart spring loaded bolt stop is primarily used for benchrest use. This is available in both blued, or stainless.

(MUST BE INSTALLED BY A QUALIFIED GUNSMITH)

Hart One Piece Bolt Stop

Master Admin — Sat, 12 Jun 2021 16:39:42 +0000

The solid one piece bolt stop is recommended for high power use, or for where more rigidity is needed. This stop is available in both blued, or stainless.

Hart Scope Ring Lapping Bar With 220 Grit Compound

Master Admin — Sat, 12 Jun 2021 16:39:28 +0000

After aligning your scope with the Hart scope alignment tool, this bar will then be used to remove any high spots from manufacture on the ring seat. The lapping bar has dual handles to give you better control when lapping, then does the single handle type. Lapping compound is included. This tool is available in: 1″, .30mm, .34mm, .35mm.

Bi-Pod Adapter

Master Admin — Sat, 12 Jun 2021 16:39:05 +0000

This is for the shooter who wants to use a bi-pod on a benchrest style stock, but doesn’t want the spring mounts to ruin the finish of their stock. This is machined from solid aluminum. This block allows the bi-pod to draw down on the seat where it belongs instead of on the edges.

Hart Arbor Press W/ Spring Return

Master Admin — Sat, 12 Jun 2021 16:39:05 +0000

The Hart arbor press has been a standard in the industry for years. The aluminum parts are anodized, and the steel parts are blued or painted. The gears are precision cut with spring return on the ram to provide ease of use. Each unit is hand assembled for smooth operation. The press is 10.5″ tall, 5.5″ wide, and 6″ deep. The arbor press is available in right or left hand models.

HART ACCURACY ASSET

Master Admin — Sat, 12 Jun 2021 16:38:28 +0000

The Accuracy Asset I provides bench rest stability for any sporter. The unit consists of an anodized aluminum three piece assembly that is attached to the stock using the sling swivel threads. Both the base and adjustable side pieces are fitted with cork strips to protect the finish. Installation takes only minutes. The base is designed to fit on top of 3 1/2″ or 4″ sandbags, enabling the enthusiast to shoot his sporter from the bench with rock-solid rigidity. The jaws can be adjusted to accommodate up to 1 3/4.” forearms. The jaws can also be removed to just attach to the sling swivel providing a 3″ flat base. The varmint hunter can enjoy that same torque and roll-free stability when shooting off of any convenient support in the field. The Accuracy Asset I is shipped with four attachment screws to assure one of the proper length being used.